Lay your fringe out on a flat surface, run a line of hot glue along a small section of it and "roll" your 14" lamp shade ring into it. Hold in place until it sets. Repeat over and over until you have glued the fringe around the lampshade ring TWICE. Trim off the excess. Repeat with the other ring.
STEP 1
Start hot gluing the lamp banding around the top of the 14" fringed lamp shade. After you glue each small section, clip it with a bulldog clip to secure it while it sets. Repeat all the way around.
STEP 2
Decide how much of a length difference you want between the two layers (mine was about 2") and carefully trim, a small section at a time. This will take a lot of "finessing" and you can make final cuts once it's hung if you need to!
STEP 3